Autofiber Saver Applicator Mitt Green and Gray

View larger

Autofiber Coating Applicator Finger Mitt with Barrier Layer (5 in. x 4 in.)

Condition: New product

The hydrophobic layer, between the outer microfiber and inner mitt layers, prevents the product from soaking through to the other side. More product is applied to the surface.

Two-tone design to keep track of each side that has been used.

Great for wheel coatings and getting into tight spaces.

5"x4"
70/30 blend
2 x 270gsm (540gsm total)

More details

₱180.00

Quantity

Color

Green and Grey
Blue and Grey

Add to wishlist

More info

The Autofiber Saver Applicator Mitt Green and Gray takes the popular saver applicator barrier from the Autofiber Saver Applicators and applies it to a finger mitt! The hydrophobic layer, between the outer microfiber layer and inner mitt layers, preventing your favorite products from absorbing into the surface so you don't waste product. This applicator can be used with virtually any detailing product but it's especially valuable with coatings that are very expensive. Additionally the material is very soft and paint safe! The two-tone design will help you keep track of each side that has been used and differentiate it from other detailing products. These mitts measure 5" x 4" fitting over two to three fingers, so you can easily control applications and reach tight or small areas with ease. Just slip the mitt over your fingers, apply some of the desired product to the mitt and you will be all set to start applying. Let your fingers do the work with the Autofiber Saver Applicator Mitt Green and Gray!

Note:If you are looking for an applicator with a microfiber makeup, a softer suede makeup, a different size, different color combination, etc, check out the entire Saver Applicator lineup!

From The Label

Product Description

This microfiber finger mitt coating applicator has an added layer of a hydrophobic material between the microfiber and inner layers.

This prevents excess coating product from soaking through the microfiber into the sponge and limits excess product buildup which can become gummy and tacky as the coating begins to cure. Saving product, time, and money!